DIY Project Sharing | Dino stickers

Inspiration
1

My Icraft arrived this morning.
I calibrated the print and cut and printed some stickers.
I notice some edges were not cut properly - a black edge was showing on one side.
I ran the calibration again and decided to print some stickers.
I heard my grandson wanted something jurassic world themed for his birthday next month.
When I saw the dinosaur characters I decided to make dinosaur stickers for my next check of the calibration.

I think the results are good and the little dinos look really cute.

1937592543165857792
19375925431658577921358×1811 276 KB

5b5a06ca7b084f4b99a7c267e509ee8f
5b5a06ca7b084f4b99a7c267e509ee8f200×200 13.8 KB

11 Likes
2

Nice job! A smooth starting :stuck_out_tongue_closed_eyes:

7 Likes
3

what a great start Roger, you can fill the little space at the botton past the corner marks if you want, that will give you an extra sticker or 2 :dragon:

8 Likes
4

Not bad for a newbie! A good way to start! Keep it up :wink:

7 Likes
5

cute project to start!

5 Likes
6

Nice stickers and for the first time this is a great result

5 Likes
7

good cut job, you look great

4 Likes
8

I had wondered about that. Thanks

5 Likes
9

Very cute stickers, you have a great cut around them too. Well done :grinning:

4 Likes
10

Cutie dinos. Nice work on the calibration :heart_eyes:

4 Likes