DIY Project Sharing | hockey Christmas ornaments

Inspiration
, ,
1

I am making a hockey themed Christmas tree this year so here is my first 4 ornament. I went for the footing image design and because I don’t have a icraft I but the circles out by hand. I put white vinyl behind the one design over the holographic laminate sheet. I think I will paint the back side of the tree design ornament to give it a snow globe type look. I hope some other Hockey fans enjoy the designs.

some fun simple hockey ornament designs. the black circle is a cut line. i printed the designs on a clear sheet the out a holographic laminate sheet to give it a little shine.

1991904360020881408
1991904360020881408722×782 43 KB

1991904365339258880
1991904365339258880803×944 52 KB

1991904368820531200
1991904368820531200749×913 81.6 KB

1991904372385689600
1991904372385689600541×682 57.1 KB

20251122001443-000033
20251122001443-000033719×719 58 KB

3 Likes
2

Really cool! Definitely a fun creative idea for ornaments for hockey lovers!

1 Like
3

Thanks I have ideas for other ornaments using the same idea of the clear sheets for floating images in ornaments.

4

I’ve seen a a couple videos of the floating ornament and really want to try it I just have to buy some ornaments to try it out

1 Like
5

I had gotten extra clear fillable ornaments after Christmas last year so I had a bunch on hand.

1 Like
6

What size ornament do you use, I feel like the ones I’ve seen at hobby lobby feel too big

7

I got the ,2.36 Inch Clear Flat Fillable ornaments they are more of a disk then a ball I got some set that had round and the disks I thought they would be good for tnis. A lot of them are 2.36 - 3in un size for fillable ones that are once pice not the two part ones.
I also have some 3in ones I think I did these in the 3in ones.