DIY Project Sharing | HTVRONT Mug Guide

Inspiration
1

This is a simple guide I made to help create mug wraps in LOKLiK Idea Studio. This is for an HTVRont 11oz Sublimation Mug. But you could easily adjust the dimensions to suit any type of mug you may have. I leave a 1cm gap on each edge to accomodate the mug handle and surrounding area that you can’t sublimate on. It also has a centre point so you can accurately get your design on either side of your mug if you don’t make a full wrap.

I hope this helps aligning and sizing of your sublimation prints.

1937389499065090048
1937389499065090048520×520 12.7 KB

d615db3eb94645dca76c349e6332789c
d615db3eb94645dca76c349e6332789c200×200 723 Bytes

6 Likes
2

Nice ideas :clap:t2:

5 Likes
3

I find it helpful so you get the right size. Would like to make more templates for tshirts and tumblers and things

3 Likes
4

I always advise my followers to measure their materials mugs or Tumbler because even though the size 11oz or 20 oz is the same but the companies could make differences so htvront mugs 11oz were different from the ones I got from a German company, the Tumblers too there is a slight difference from one company to another this is why I always say and do measure every material :wink:

4 Likes
5

Very useful Belle :coffee:

3 Likes
6

Great tip specially to those beginners in this sublimation era.

2 Likes
7

great tip!

2 Likes
8

Oh yes, you should measure the size of your blank. Then you can just adjust this template to suit your size blank.

2 Likes
9

Thank you :heart_eyes:

2 Likes
10

Yes, I have had so many people say. What am I doing wrong because it’s not sublimating near the handle. Hopefully this guide helps.

3 Likes
11

Thank you :heart_eyes:

2 Likes