Did you know? You can layout your designs beyond the registration marks, and the machine will still cut them! As you can see, my images go past the registration marks, yet the machine cuts them perfectly. This is a game changer for maximizing your cutting area!
19 Likes
I thought we could do that due to marks on the calibration sheets but never tried it thanks for the info
7 Likes
It’s nice right? Atleast we can somehow maximize the sheet but it will be way better if we could adjust the registration marks😁
9 Likes
You should tried can give more designs to cut even the spave under registration marks you can still put designs their
5 Likes
I didn’t know this.Thankyou
6 Likes
ok this might help me, do the registration marks stay the same whether you use 8 x 11 or 12 x 12 card stock? I wanted to make a popcorn box and the registration marks are no where near the end of the design
6 Likes
Registration marks cannot be adjusted yet
3 Likes
great tip! 
4 Likes
Welcome! 
3 Likes
How do you get registration marks then to be wider when using 12 x 12 card stock ? I set up the page format on the side I chose 12 x12 . But it continues to show I am using 8 x 11 . For example when I tried to do a popcorn box from their project selection only 3 of 4 sides printed because the 4 th side was beyond 8 inches
5 Likes
Print and cut is only for a4 size I think. Maybe the @admins can help
4 Likes
The Print Then Cut feature is not compatible with 12x12" paper. It is designed to work with standard US Letter (8.5x11") or A4-sized paper 
5 Likes