Materials default parameters

[RuneKC]

Hi, can the material cutting parameters be reset to default? I can’t find any info about this in the software

best regards

Rune

[timmytation]

Let’s ask the @admins. I’m not sure if this can be done

[jna_dow]

I would like to know also

[redhada]

Hi @Rune! The material cutting parameters are always set to default unless you personalize them. Even then, it´s only for that task, next time they will be default again.

The default parameter you can really modify the default is cutting calibration:

and that can be reset to default: