rinsky
September 23, 2025, 2:50pm
10
Oh, I see! I know you got positive values for the last two rows, but did you try making them negative to see what happens? - NO NEED TO DO THAT! Just perform a second calibration like @Marino suggested.
You can also check this link from @BellethehowtoGuru for your reference only!
Hi, these results are a bit alarming. What machine are you using? Is your software up to date and your firmware up to date on your machine? When you calibrate for print then cut the results are what ever line was cut in the center. All results do not have to be 0. Making them all 0 when they are not leads to these results. I have videos that walk you through the print then cut calibration process.
This video shows the LOKLik crafter print then cut calibration
[LOKLiK Crafter Print Then …
2 Likes
