Tried print and cut with the Loklik iCraft I redeemed using my Cheers Points. Here were the results. Reading of registration marks was a breeze even with using Glossy Photo Sticker paper (with Holographic stickers it was able to read but the cuts were waaaay off) . I did not get any failed to red registration marks warning.
I did calibrate before doing the print and cut though. But compared to the Loklik Crafter, the iCraft cut stickers better since it was able to read registration marks without much fail.
These look great. Yes, I think the main problem with the crafter is the sensor that reads the registration marks unfortunately. This problem can’t be fixed in a software update because it’s a hardware issue.
Yes, the Crafter wasn’t quite consistent with reading the registration marks. Even with regular copy paper I usually get failed to read the registration marks which was very frustrating. I’m still hoping they can fix the Crafter issue, it’s still a good machine though for standard cuts
Hope you get yours already I also wish Loklik removes the Lower right registration marks since the machine only reads the other 3, so we can maximize that space
did you upload the cars as one sheet? Or every car at once
