Stampa e taglio

[redhada]

And then you can try this:

I am using icraft 6 months but still the print and cut function is not accurate. I already lost client because of uneven cuts and measurement

Reading again… I don´t know why I think this is going to be a case of that many calibrations that the machines goes crazy. Too many calibrations doesn´t work. You only need to: Reset calibration Be sure you print a calibration sheet scaled 100% Be sure the reading marks are well printed. If you’re not sure, go over them with a black pen Avoid dule and excesive lighting and glossiness in the reading marks Perform the calibration up to three times. Even if you see any line not exactly accurate, …