Stampa e taglio

[Michela_Mascia]

Buongiorno, qualcuno da dirmi come mai il mio plotter taglia sbagliato ciò che ho stampato anche se ho fatto la regolazione iniziale? Grazie mille
Michela

[rinsky]

Hi and Welcome to the community @Michela_Mascia! Please take a look attached link below for your reference only. Hope it solves your issues. Please keep us updated!

Having problems creating accurate outline offset

Gi wheel! There are several topics on this matter, let point some: Crafter Notes | Need a Hand with Calibration? These Tips Might Help Machine Calibration Print and cut (calibrate) LOKLIK Icraft - print & cut issues? tips? You can search for more, as there are many. It is more or less always the same. I’m sure @rinsky has a saved layout to answer this Updated software and firmware A good calibration Proper printed calibration marks Good lighting conditions avoiding both lack of l…

[redhada]

And then you can try this:

I am using icraft 6 months but still the print and cut function is not accurate. I already lost client because of uneven cuts and measurement

Reading again… I don´t know why I think this is going to be a case of that many calibrations that the machines goes crazy. Too many calibrations doesn´t work. You only need to: Reset calibration Be sure you print a calibration sheet scaled 100% Be sure the reading marks are well printed. If you’re not sure, go over them with a black pen Avoid dule and excesive lighting and glossiness in the reading marks Perform the calibration up to three times. Even if you see any line not exactly accurate, …