UNIQUE KEYFOBS with HTV print

Inspiration
1

IMG_7972
IMG_79723024×4032 2.59 MB

HTV in keyfobs

Materials Needed

  1. Keyfob (made of fabric, felt, or other heat-tolerant materials)
  2. HTV vinyl (i choose Soft Mettalic Gold)
  3. Loklik Mini heat Press V3
  4. Weeding tool or scraper
  5. Loklik Crafter to cut vinyl
  6. Ruler or straightedge
  7. Parchment paper or heat-resistant tape

Steps

  1. Create your design using a loklik ideastudio.

  2. Mirror your design, as HTV vinyl is applied with the carrier side up.

  3. Cut Out Your Design with loklik crafter

  4. Weed Your Design. Use a weeding tool or scraper to remove excess vinyl from the design.

  5. Prepare Your Keyfob
    Place your keyfob on a flat surface.
    Make sure the area where you’ll be applying the HTV vinyl is clean and dry.

  6. Apply the HTV Vinyl
    Place the HTV vinyl design onto the keyfob, positioning it as desired.
    Cover the design with parchment paper or heat-resistant tape.
    Place the keyfob under the heat press machine.

  7. Heat Press the Design
    Set the heat press machine to the recommended temperature (usually around 300-320°F). Set the pressure to medium-high.
    Press the design for the recommended time (usually around 10-15 seconds).
    Remove the keyfob from the heat press machine.

  8. Peel Off the Carrier
    Allow the design to cool for a few seconds.
    Peel off the carrier side of the HTV vinyl, starting from one corner.

Your keyfob is now complete!

6 Likes
2

This is a great little project. I really like that font too.

3 Likes
3

Cool I love the htv and font :heart_eyes:

3 Likes
4

if im not mistaken called Christmas

3 Likes
5

I love the shimmer of the htv. That’s cute :heart_eyes:

3 Likes
6

Soft HTV textured into the fabric well.

3 Likes
7

Did you get it from dafont.com?

2 Likes