Hi @GeorgeneZitek. I’m sorry you are facing issues. Do you have the iCraft (cutting machine 2)? I would make sure IdeaStudio is up to date and your firmware is up to date. After these are, I would perform a reset calibration to reset the values of your print then cut. Then do a print then cut calibration and input the values you see the line is cut through the center. After calibration is complete test your print the cut by using shapes to test. If the print then cut is off, repeat a print the cut calibration and test. You can use this pre-made test sheet for three tests if you would like. Project | Print then Cut Test sheet
This video may help you see what I did to calibrate mine